Rogue Trooper WHDLoad Pack

README

 THIS PACKAGE COMES WITH ABSOLUTELY NO WARRANTY OF ANY KIND, EITHER EXPRESS OR
 IMPLIED, STATUTORY OR OTHERWISE. THE ENTIRE RISK AS TO USE, RESULTS AND
 PERFORMANCE OF THE PACKAGE IS ASSUMED BY YOU AND IF THE PACKAGE SHOULD PROVE
 TO BE DEFECTIVE, YOU ASSUME THE ENTIRE COST OF ALL NECESSARY SERVICING,
 REPAIR OR OTHER REMEDIATION.
 UNDER NO CIRCUMSTANCES, CAN THE AUTHOR BE HELD RESPONSIBLE FOR ANY DAMAGE
 CAUSED IN ANY USUAL, SPECIAL, OR ACCIDENTAL WAY, ALSO IF THE OWNER OR A THIRD
 PARTY HAS BEEN POINTED AT SUCH POSSIBILITIES OF DAMAGE.

 This install applies to "Rogue Trooper" © 1990 Krisalis.

 Requirements:
 -------------
 This install requires WHDLoad and DIC to be in the path.
 These programs can be found in the WHDLoad package.
 To install from a different drive than DF0: select installation mode Expert.

 The installed game requires 0.5 MB ChipMem (+0.9 MB for preload)
 It can be quit by pressing F10 (key can be changed with Tooltype "QuitKey=").


 History:
 --------
 version 1.2 (24.02.2022) done by StingRay:
 - patch redone
 - another version supported (issue #5491)
 - access fault in shop part fixed
 - Atari ST code disabled (write to $ffff8240)
 - highscore load/save
 - lots of trainer options added (for all game parts!)
 - blitters wait added (patches can be disabled with CUSTOM2)
 - decruncher optimised and error check added
 - source code included
 - 68000 quitkey support 
 - new install script

 version 1.1 (12.07.2010) done by Bored Seal:
 - trainer added
 - decruncher moved to Fast RAM
 - protection check in level 5 removed (thanks to Ville Haapanen for report/test)

 version 1.0 (29.10.2000) done by Bored Seal:
 - initial release

 Notes for the V1.2 update:
 --------------------------

 The patch now supports 2 versions of the game (SPS 1414 and another one).
 I have added lots of trainer options, the shooter part has been trained
 too of course. There also was an interesting access fault in the shop
 part (where you can buy equipment for your ship), due to a wrong call
 to the routine for blitting the picture, the first byte of the crunched
 data was trashed.

 Highscore load/save has been added as well, saving will be disabled
 if any trainer options are used.




Thanks to Richard Wagenfuhrer for disk image.


 Contact:
 --------
 If you have problems with this installation please try and get a newer
 version of this package from the WHDLoad WWW-Page. If that doesn't help try
 some Tooltypes like NOCACHE, NOAUTOVEC, EXPCHIP, NOMMU, PAL or NTSC. If
 that also fails, please inform the author via the Bug-Report-Form which
 can be accessed on the WHDLoad WWW-Page.

 For the full WHDLoad package, other installs and updates refer to:
	http://www.whdload.de/
 or	aminet:dev/misc/whdload#?
 and	aminet:game/patch/